EasyManuals Logo
Home>Eaton>Microphone system>UltraShift PLUS FOM-16E310C-LAS

Eaton UltraShift PLUS FOM-16E310C-LAS User Manual

Eaton UltraShift PLUS FOM-16E310C-LAS
263 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
195
© 2017 Eaton. All rights reserved
2018.12.12
Release Yoke and Cross-Shaft(s) Removal and Installation | Service Procedures TRSM0940
Release Yoke and Cross-Shaft(s) Removal
Note: The Transmission and ECA must be removed prior to
removing the Release Yoke and Cross-Shaft(s).
1. Remove
the upper and lower Cross-Shaft mounting
cap screws and lock washers from the Release Yoke.
2. Remove the
Cross-Shaft Plug with O-ring.
3. Push the upper
Cross-Shaft up out of the Release Yoke
and remove the Yoke.
4. Remove the lower
Cross-Shaft and Release Yoke.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton UltraShift PLUS FOM-16E310C-LAS and is the answer not in the manual?

Eaton UltraShift PLUS FOM-16E310C-LAS Specifications

General IconGeneral
BrandEaton
ModelUltraShift PLUS FOM-16E310C-LAS
CategoryMicrophone system
LanguageEnglish

Related product manuals