CONNECTING TO THE NETWORK
13
Append one of the following suffixes that corresponds to the Fiery X3eTY2 print connection
to the end of the NetWare queue names, as follows:
_print
_hold
_direct
N
OTE: These suffixes must be in English and in all lowercase letters.
You do not need to perform Setup when you add or remove a NetWare queue. However,
always restart the Fiery X3eTY2 after you create or remove a queue that will be connected to
the print server used by the Fiery X3eTY2.
When the Fiery X3eTY2 is configured to connect to a NetWare server, it polls the NetWare
server for jobs in each of its queues. If jobs are found, they are automatically transferred over
the network to the matching connection on the Fiery X3eTY2. For example, jobs from the
NetWare queue with the _print suffix are sent to the Fiery X3eTY2 Print queue.
•You can connect up to eight bindery servers to the Fiery X3eTY2.
NOTE: The NetWare bindery server you select must not be in the same tree as the one you
selected in NDS Setup, if both NDS and bindery are used by the Fiery X3eTY2.
AppleTalk networks
AppleShare servers require no special configuration.
UNIX networks
• When you configure a UNIX workstation with the lpr protocol and connect to the Fiery X3eTY2
over a TCP/IP network, you can print directly to the Fiery X3eTY2.
• Setting up UNIX workstations requires an administrator with root privileges. After the initial
configuration, UNIX users submit print jobs to a named printer.
• The Fiery X3eTY2 is a printer controller that understands lpr protocols.
To Next Page
Loading...
Need help?
General
