SETTING UP THE FIERY X3ETY2 FROM THE COPIER TOUCH PANEL
24
Main Setup menu
The Setup menu provides many of the options available from Command WorkStation.
Choose the following commands from this menu:
Job List
Displays properties of currently printing and queued jobs, and allows you to print jobs.
Print Pages
Print system pages from the Fiery X3eTY2. You can print the following pages from the
submenu that appears:
PS Test Page: A Test Page allows you to confirm that the Fiery X3eTY2 is properly connected
to the copier, and provides color and grayscale samples to troubleshoot problems with the
copier or the Fiery X3eTY2. Settings on the Test Page may include: Server Name, color
settings, printer model, and date and time the Test Page was printed.
Configuration: Prints the Configuration page, which gives the current server and device
configuration. This page lists general information about the hardware and software
configuration of the Fiery X3eTY2, the current options for all Setup settings, information
about the current calibration, and the IP address of the Fiery X3eTY2.
Job Log: Prints a log of the last 55 jobs.
Control Panel Map: Prints the Control Panel Map, which is an overview of the screens you
can access from the copier touch panel.
Color Charts: Prints samples of the RGB, CMY, and PANTONE colors available from the
Fiery X3eTY2.
Font List: Prints a list of all fonts currently on the Fiery X3eTY2 hard disk.
E-mail Log: Prints a log listing recent e-mail activity. This E-mail log is useful to the network
administrator.
FTP Log: Prints an FTP log listing recent FTP activity. This FTP log is useful to the network
administrator.
NOTE: To print the E-mail or FTP log, you must first enable the appropriate service. For
information about enabling these services, see Configure Help.
Suspend Print
Suspend communication between the Fiery X3eTY2 and the copier. Use this command to
interrupt the current Fiery X3eTY2 job and use the copier to make copies or print another
job first. Jobs continue to process on the Fiery X3eTY2. After you make copies from the
copier or complete maintenance tasks, choose Resume Printing to continue printing jobs
from the Fiery X3eTY2.
Resume Print
Resume communication between the copier and the Fiery X3eTY2 after you have selected
Suspend Printing.
Calibration
Calibrate the Fiery X3eTY2 using ColorCal. For more information, see Color Printing. If an
Administrator password has been set, you must enter it to access Calibration.
To Next Page
Loading...
Need help?
General
