EFI Fiery X3eTY2 User Manual

PREPARING FOR FIERY X3ETY2 SETUP
21
About Setup
Setup configures the Fiery X3eTY2 to communicate with other devices and to manage print
jobs. Perform Setup the first time you turn on the Fiery X3eTY2 after new system software is
loaded, or any time Server software is reinstalled. When the network or user printing
environment changes, change the options accordingly.
NOTE: You cannot access Setup functions from Command WorkStation, Macintosh Edition.
Setup from the copier touch panel
The first time you perform Setup, you must use the copier touch panel. Make settings for, at a
minimum, Server Setup, Network Setup 1, and Network Setup 2, in that order. After the
initial Setup, you can change Setup options from the copier touch panel (page 23) or a
network computer (page 31). Because Setup from the copier touch panel is minimal, most
Setup options can be set using only the network computer method.
If you do not make settings in the remaining Setup menus, the Fiery X3eTY2 uses default
settings. Make sure that the settings are appropriate for the printing environment at your site.
Setup from a network computer
To set up the Fiery X3eTY2 from a network computer, use Configure. You can access
Configure from either WebTools or Command WorkStation, Windows Edition.

EFI Fiery X3eTY2 Specifications

General

Brand	EFI
Model	Fiery X3eTY2
Category	Printer
Language	English