SETTING UP THE FIERY X3ETY2 FROM THE COPIER TOUCH PANEL
28
Network Setup 1 options
When you perform Network Setup, you configure the Fiery X3eTY2 to receive jobs over the
network systems that are used at your site, including setting network addresses and names to
be used by workstations, servers, and the Fiery X3eTY2 when they communicate with each
other.
Before performing Network Setup, confirm that the Fiery X3eTY2 is connected to an active
network because the Fiery X3eTY2 queries the network for zones, servers, and server-based
queues. If you perform Network Setup without a connected and functioning network, default
settings are used that may not meet your needs.
Default settings, where applicable, appear in this document with square brackets. If your
network requirements change, you can change Network Setup at any time.
Ethernet Speed
Auto Detect/1 Gbps/100 Mbps Full-Duplex/100 Mbps Half-Duplex/10 Mbps Full-Duplex/
10 Mbps Half-Duplex [Auto Detect]
Select an appropriate setting according to the settings of the network to which the
Fiery X3eTY2 is connected. Select Auto Detect if your network environment is mixed or if
you do not know the network speed.
NOTE: The 1 Gbps (gigabit per second) setting is full-duplex.
TCP/IP Setup
Manual/DHCP/BOOTP [DHCP]
Specify whether to enter a static IP address or whether you want to select the protocol over
which the Fiery X3eTY2 searches for its IP address. Both DHCP and BOOTP allow the
Fiery X3eTY2 to obtain the Ethernet IP address and subnet mask automatically.
Depending on your network, the Fiery X3eTY2 might be assigned a different address after
you restart the Fiery X3eTY2. With the DHCP setting, the Fiery X3eTY2 can be assigned a
different address even if it is not restarted. Make sure the network is already configured
properly for the protocol you select.
IP Address
[127.0.0.1]
If you selected Manual for the TCP/IP Configuration option, enter the Fiery X3eTY2 IP
address. This IP address, unlike an IP address set automatically, remains the same if you restart
the Fiery X3eTY2. You must change the default to a valid address for your network. For
information about setting up printing with TCP/IP, see page 12.
Subnet Mask
[255.255.255.0]
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
NOTE: Confirm the subnet mask setting with your network administrator before proceeding.
To Next Page
Loading...
Need help?
General
