To Next Page

To Previous Page

PREPARING FOR FIERY X3ETY2 SETUP

Connecting network cable to the Fiery X3eTY2

This section includes an illustration of the Fiery X3eTY2 back panel, and provides

information about connecting the Fiery X3eTY2 to the network.

Back view of the Fiery X3eTY2

Ethernet connection

For Ethernet connections, the Fiery X3eTY2 supports Unshielded Twisted Pair (UTP) cabling

for these network speeds:

• 10BaseT: Category 3 or higher

• 100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)

• 1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)

TO CONNECT TO THE NETWORK

• Connect the cable from the network to the appropriate network connector (RJ-45) on the

back of the Fiery X3eTY2.

1 USB ports (Type A)

2 Network connector

3 Not used

4 Copier connector

5Power switch

6Soft power button

Questions and Answers:

Need help?

Do you have a question about the EFI Fiery X3eTY2 and is the answer not in the manual?

EFI Fiery X3eTY2 Specifications

General