To Next Page

To Previous Page

CONNECTING TO THE NETWORK

This chapter summarizes the stages in setting up the Fiery X3eTY2.

Fiery X3eTY2 on the network

When the Fiery X3eTY2 is connected to a network, it behaves as a networked printer. The

Fiery X3eTY2 supports the following network protocols (rules that enable computers on a

network to communicate with each other):

•AppleTalk

•TCP/IP, which also includes the BOOTP, DHCP, FTP, HTTP, IMAP, IPP, IPv4, IPv6,

LPD, NBT, POP3, Port 9100, SMB, SMTP, SNMP, SNTP, and SSL/TLS protocols

• IPX/SPX (Novell)

These protocols can run concurrently on the same cable. Computers that use other protocols

can print through a server that uses one of the supported protocols. The Fiery X3eTY2 is

auto-sensing, and handles all connections simultaneously.

Questions and Answers:

Need help?

Do you have a question about the EFI Fiery X3eTY2 and is the answer not in the manual?

EFI Fiery X3eTY2 Specifications

General