Emerson Micro Motion Configuration And Use Manual

Contents
Part I Getting Started
Chapter 1 Before you begin ............................................................................................................3
1.1 About this manual ....................................................................................................................... 3
1.2 Model codes and device types ..................................................................................................... 3
1.3 Communications tools and protocols .......................................................................................... 4
1.4 Additional documentation and resources .................................................................................... 5
Chapter 2 Quick start .....................................................................................................................7
2.1 Power up the transmitter .............................................................................................................7
2.2 Check meter status ......................................................................................................................7
2.3 Make a startup connection to the transmitter ..............................................................................8
Part II Configuration and commissioning
Chapter 3 Introduction to configuration and commissioning ....................................................... 13
3.1 Default values ............................................................................................................................13
3.2 Enable access to the off-line menu of the display ....................................................................... 13
3.3 Disable HART security ................................................................................................................13
3.4 Set the HART lock ...................................................................................................................... 16
3.5 Restore the factory configuration .............................................................................................. 16
Chapter 4 Configure process measurement ..................................................................................19
4.1 Verify the calibration factors ......................................................................................................19
4.1.1 Calibration factors ...................................................................................................... 20
4.2 Configure line density measurement ........................................................................................ 20
4.2.1 Configure Density Measurement Unit ................................................................................20
4.2.2 Configure Density Damping ............................................................................................ 22
4.2.3 Configure Density Cutoff ................................................................................................ 23
4.2.4 Configure two-phase flow parameters ........................................................................ 24
4.3 Configure temperature measurement .......................................................................................25
4.3.1 Configure Temperature Measurement Unit ........................................................................ 25
4.3.2 Configure Temperature Damping .....................................................................................26
4.3.3 Configure Temperature Input .......................................................................................... 27
4.4 Configure the pressure input ..................................................................................................... 31
4.4.1 Configure the pressure input using ProLink III ............................................................. 31
4.4.2 Configure the pressure input using the Field Communicator .......................................32
4.4.3 Options for Pressure Measurement Unit ........................................................................... 33
4.5 Set up the API referral application ..............................................................................................34
4.5.1 Set up the API referral application using ProLink III ...................................................... 34
4.5.2 Set up the API referral application using the Field Communicator ............................... 40
4.6 Set up concentration measurement .......................................................................................... 46
4.6.1 Preparing to set up concentration measurement ........................................................ 46
4.6.2 Set up concentration measurement using ProLink III ...................................................47
4.6.3 Set up concentration measurement using the Field Communicator ............................54
Contents
Configuration and Use Manual i

Emerson Micro Motion Specifications

General

Brand	Emerson
Model	Micro Motion
Category	Measuring Instruments
Language	English