Using the Control Panel 181
EPSON AcuLaser C3800 User's Guide
*5
When the Get IPAddress setting is changed from Panel or PING to Auto, the panel setting values are
saved. When Auto is changed to Panel or PING, the saved setting values are displayed. 192.168.192.168
if the settings are not made from the panel.
USB I/F
Allows you to activate or deactivate the USB interface.
USB SPEED
Allows you to select the operation mode of USB interface. Selecting HS is recommended.
Select FS if HS does not work on your computer system.
Buffer Size
Determines the amount of memory to be used for receiving data and printing data. If
Maximum is selected, more memory is allocated for receiving data. If set to Minimum is
selected, more memory is allocated for printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five seconds then
turn it back on. Or, you can perform a Reset All operation, as explained in "Reset Menu" on
page 179.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not flashing when you
reset the printer.
Network Menu
See the Network Guide for each setting.
AUX Menu
See the Network Guide for each setting.
USB Host Menu
This menu allows you to use the USB Host printing function. For instructions on using the
function, see "Printing Directly from a USB Memory" on page 206.
Item Settings (default in bold)
USB Host
*1
On, Off
Device Detection
*2
Manual, Auto
To Next Page
Loading...
Need help?
General