Paper Handling 43
EPSON AcuLaser C3800 User's Guide
When loading envelopes, you should make paper settings as shown below:
❏ Make settings on the Basic Settings in the printer driver.
Note:
Depending on the condition of the paper, the printer may fail to feed paper properly when the
maximum amount of paper is loaded. If this happens, reduce the amount of paper loaded in the
tray.
❏ You can also make these settings on the Tray Menu in the control panel. See "Tray
Menu" on page 172.
Please note the following when handling this media.
❏ When printing on C5 or ISOB5 size envelopes, load them with the short edge first.
When printing on DL size envelopes, load them with the long edge first.
a. C5 or ISO B5
b. DL
❏ Do not use an envelope that has glue or tape on it.
Labels
You can load up to 15 mm thickness of labels into the MP tray at a time. However, you may
need to feed some labels one sheet at a time, or load them manually.
Note:
❏ Duplex printing is not available for labels.
❏ When printing on labels, you cannot set the printing resolution to 1200 dpi.
❏ Depending on the quality of labels, the printing environment, or the printing procedure, labels
might be wrinkled. Make a trial print run before you print on a lot of labels.
Paper Size: IB5, DL, or C5
Paper Source: MP Tray (up to 15 mm thick stack)
b
a
To Next Page
Loading...
Need help?
General