c
Important:
When performing level adjustment using the
adjusters, make sure you raise the adjusters
above the casters before trying to move the
printer. Moving the printer without raising the
adjusters could cause malfunction. You need
the spanner supplied to adjust the adjusters.
1. Loosen the nut on the top of the adjuster.
2. Turn the nut on the bottom
counter-clockwise.
3. Check that it is above the caster.
F
Move the printer.
Have 2 people, 1 on either side of the printer,
move the printer.
If you are using the SC-S80600L Series/
SC-S60600L Series, use a total of 3 people for
moving: 2 to move the printer and 1 to move the
ink unit. Also, move so that the printer goes first
in the direction you are going.
c
Important:
Use the casters on the dedicated printer stand
to move the printer indoors a short distance
over a level floor. They can not be used for
transport.
Post-Move Setup
After moving the printer, follow the steps below to ready
it for use.
A
Check that the new location is appropriate, and
attach the parts that were removed.
U Setup Guide
If you do not have the Setup Guide on hand, select
and refer to the model of your printer from
https://epson.sn.
B
Plug in the power cables and turn the printer on.
U Setup Guide
C
Perform a nozzle check to check for clogged
nozzles.
U “Printing nozzle check patterns” on
page 85
D
Perform Media Adjust in the setup menu, and
check the print quality.
U “Optimization of media settings (Media
Adjust)” on page 48
Transport
Before transporting the printer, contact your dealer or
Epson Support.
U “Where To Get Help” on page 141
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Appendix
133
To Next Page
Loading...
Need help?
General