D
Place the new ink supply unit into the tray and
lower the handle.
E
While the ink supply unit is in the tray, as shown
in the illustration below, carefully shake it by
tilting it up and down at about a 60 degree angle 5
times in 5 seconds.
In the case of OR, WH, or MS, shake it well
approx. 25 times in 25 seconds.
F
Match the color on the label on the ink supply
unit with the label on the ink unit, and then fully
insert the tray.
G
Move the lock switch to the left to lock it.
Repeat steps 2 to 7 to replace other ink supply
units.
c
Important:
Place ink supply units in all the trays, and then
insert them into the ink unit. Printing is not
possible if, for even one color, an ink supply
unit is not loaded into a tray or a tray is not
inserted into the ink unit.
DisposalU “Disposal” on page 84
Disposing of Waste Ink
Preparing and Replacement
Timing
Prepare empty waste ink bottle. is displayed
Prepare a new Waste Ink Bottle as soon as possible.
When you want to replace the Waste Ink Bottle at this
stage due to night operations and so on, select Replace
Ink Bottle from the setup menu, and then replace the
bottle. If you perform the replacement without selecting
Replace Ink Bottle, the waste ink counter will not
operate correctly.
Maintenance menu U “The Maintenance Menu” on
page 110
Waste Ink Counter U “Waste Ink Counter” on
page 77
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Maintenance
76
To Next Page
Loading...
Need help?
General