❏ Although the ink cartridges/ink supply units may
contain recycled materials, it does not affect the
printer's function or performance.
❏ Do not dismantle or remodel ink cartridges/ink
supply units. You may not be able to print properly.
❏ Do not drop or knock the ink cartridges/ink supply
units against hard objects; otherwise ink may leak
from them.
❏ Ink cartridges/ink supply units loaded in the printer
or the ink unit (except for WH and MS) must be
removed and thoroughly shaken once every 3
weeks.
WH and MS must be removed and thoroughly
shaken every day before starting printing work.
You do not need to shake the cleaning cartridge/
cleaning ink supply unit.
Shaking Ink CartridgesU “Shaking” on
page 71
Shaking Ink Supply UnitsU “Shaking” on
page 74
Notes on Handling the Ink Unit
(SC-S80600L Series/SC-S60600L
Series)
❏ Use screws and fixing wire to fasten the fixing wire
to the front and back of the printer's legs. The ink
tube may break if you move the ink unit while it is
connected to the printer without being fastened
with the fixing wire.
❏ Do not remove the ink tube connector after it is
connected in setup. Ink may leak if you remove this
without paying close attention.
Handling Media
Note the following when handling or storing media.
Media that are in poor condition will not produce good
quality prints.
Be sure to read the documentation provided with each
type of media.
Notes on Handling
❏ Do not fold the media or damage the printable
surface.
❏ Do not touch the printable surface. Moisture and
oils from your hands can affect print quality.
❏ When handling media, hold it by both edges. We
recommend wearing cotton gloves.
❏ Keep the media dry.
❏ Packaging materials can be used to store media and
should not be thrown away.
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
❏ When not in use, media should be removed from
the printer, rewound, and inserted in its original
packaging for storage. Leaving media in the printer
for extended periods may cause it to deteriorate.
Handling Media After Printing
To maintain long lasting, high quality print results, note
the following points.
❏ Do not rub or scratch the printed surface. If they are
rubbed or scratched, the ink may peel off.
❏ Do not touch the printed surface, as this may
remove the ink.
❏ Make sure printouts are completely dry before
folding or stacking, otherwise discoloration or
other marks may appear where the prints touch.
These marks will disappear if the prints are
immediately separated and dried but will become
permanent if the surfaces are not separated.
❏ Avoid direct sunlight.
❏ To prevent discoloration, display and store prints as
instructed in the documentation supplied with the
media.
Notes on Usage of WH/MS
Ink (SC-S80600 Series/
SC-S80600L Series)
WH/MS inks may sediment (components settling to the
bottom of the liquid) easier than other inks due to ink
characteristics. Sedimentation triggers tint unevenness
in printing results or clogged nozzles.
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Introduction
23
To Next Page
Loading...
Need help?
General