Changing settings during
printing
Changing the Heater
Temperature and Drying
Settings
Buttons that are used in the following settings
A
Press the [ ] button during printing.
The Heating & Drying menu is displayed.
B
Use the d/u buttons to select the desired item
and press the Z button.
C
Choose a value.
Heater Temperature
(1)
Use the r/l buttons to select a heater. From
left, the items are pre-heater, platen heater, and
after heater.
(2)
After selecting the desired heater, use the d/u
buttons to choose the temperature.
Additional Dryer
Use the d/u buttons to select items.
D
When you press the Z button, the settings for
the currently selected media are updated, and the
Heating & Drying menu is displayed.
E
When you press the y button, the menu is closed
and the status display screen is displayed.
Note:
The time needed for the heaters to reach the
specified temperatures varies with the ambient
temperature.
Correcting Banding
When you want to correct banding during printing,
perform Feed Adjustment.
Buttons that are used in the following settings
A
Press the M button during printing.
The current adjustment value is displayed.
B
Use the d/u buttons to change the current value.
If the feed amount is too small, black bands (dark
stripes) will appear; adjust the feed amount
upwards.
If, in contrast, the feed amount is too large, white
bands (pale stripes) will appear; adjust the feed
amount downwards.
C
Check the printing result. If you are not satisfied
with the results, use the d/u buttons to change
the value.
This updates the setting value of Feed
Adjustment in the currently selected media
settings.
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Basic Operations
55
To Next Page
Loading...
Need help?
General