U
While holding the tabs of the media edge plate on
both sides, move the plate to the top edge edge of
the media.
Adjust so that the edges of the media are aligned
with the center of the round holes in the media
edge plates.
c
Important:
❏ Do not use the media edge plates with
media that is 0.4 mm or more thick. The
media edge plates could touch and
damage the print head.
❏ Always position the plates so that the edges
of the media are at the centers of the round
holes. Incorrect positioning causes
banding (horizontal banding, tint
unevenness, or stripes) during printing.
❏ Move the media edge plates to the left and
right edges of the platen when they are not
in use.
❏ Do not use the media edge plates if the
sides of the printed media are smudged.
V
Using the Auto Take-up
Reel Unit
The Auto Take-up Reel Unit automatically takes up
media as it is printed, improving the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side out Printed side in
Taking-up with printed side out places the printed
surface on the outside of the roll.
Taking-up with printed side in places the printed
surface on the inside of the roll.
You can check the procedure in a video on YouTube.
Epson Video Manuals
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Basic Operations
36
To Next Page
Loading...
Need help?
General