149
Chapter 3 Handling
3
Long-term Storage of the Product After Ink Charging
Storing the product
When not using the printer for an extended period of time after ink charging (after starting using),
store it following the steps below.
1
Run a nozzle check print to check that no dot missing or other printing prob-
lems have occurred. In case any printing problems have occurred, run
manual head cleaning so that the printer recovers from the problem.
See "Test printing" on page 76
2
After printing has completed, turn off the printer with the printer power but-
ton.
3
Store the printer in a cool (0 to 25°C {32 to 77°F}) and dark place.
CAUTION
If dot missing has occurred, ink may clot inside the nozzle to cause nozzle clogging,
making it difficult for the printer to recover from the problem when the printer restarts.
Dot missing may occur especially after transporting the printer from the place where it is
used to the place where it is stored, due to vibration.
CAUTION
When powering off the product before storing for an extended period of time, make sure
to push the Power Button.
When the Dip switch 1 is set to ON (Power button action is set to "Reset this product"),
set the Dip switch 1 to OFF.
See "Setting the Dip Switches" on page 147
CAUTION
Storage length is 6 months.
Store the product with the ink cartridge installed in the product.
To Next Page
Loading...
Need help?
General
