22
Nozzle Verification Technology
This product has an "Nozzle Verification Technology” that detects missing dots. You can select the
“Nozzle Verification Technology Enable / Disable”, “Nozzle check interval” and/or “Threshold of
clogged nozzles”, depending on level of requirement for missing dots.
And when unrecoverable clogging occurs, this print
er is able to carry out supplemental printing
using a nearby nozzle.
If you set “Enable” for the nozzle clog auto supplement system, it will be possible to remedy a
marked fall in print quality and barcode quality due to an irrecoverably clogged nozzle.
Setting the Nozzle Verification Technology
If you set “Enable” for the Nozzle Verification Technology, missing dot detection, for detecting
nozzle dropout, will be executed at the “Nozzle check interval” that you have set, that is, each time
the set print length is reached.
If the number of nozzle dropouts that is detected exceeds the “Threshold of clogged n
ozzles” that
you have set, auto head cleaning will be executed to eliminate dot dropout.
Perform a nozzle check even after auto cleaning, and if the number of dropouts does not fall below
the set “Threshold of clogged nozzles“, perform auto cleaning again.
CAUTION
This “Auto nozzle check” system cannot detect 100% of dot missing cases. It cannot detect
100% of missing dots and ink droplet curvature.
Print head maintenance is executed for all heads simultaneously. It is not executed only for
the heads and ink in which nozzle clogging was detected.
The auto nozzle check uses a small amount of ink.
After detecting a missing dot, cleaning is performed automatically and ink is also used in the
cleaning.
To Next Page
Loading...
Need help?
General
