156
Driver
CUT UNAVAILABLE
In cutter unavailable state
Autocutting is being
performed 2 or more
times with the paper in
the same position.
Execute paper feed or printing operation.
To prevent occurrence of paper scraps, do
not execute auto cutting two or more times
without feeding the paper.
SERVICE MODE
In service mode
The product is in the
mode for performing
repairs and inspections.
-
SERVICE SOON ##
##: F0, F1
Service due soon
The product is near the
end of its service life.
Because the internal parts of the printer are
near the end of their service life, prepare to
replace the printer, or prepare a printer for
replacement. When the status changes to
“Service required”, the printer will not recover
until the necessary repairs are performed and
the necessary area of the nonvolatile memory
is overwritten.
PRINTING-NOZZLE CHECK
DISABLED
Nozzle Verification
Technology is disable
Nozzle Verification
Technology is disable, or
ambient temperature
exceeds the operating
range
Go to the setting items on the panel and set
Nozzle Verification Technology to “Enable”.
Or, adjust the room (ambient) temperature
to within the range from 5 to 35 °C
{41 to 95°F}.
State Cause Recovery method
Status cannot be
obtained with the
status monitor.
"Enable the bi-
direction support" in
the "Port" setting of the
driver properties is
disabled.
When using an Epson printer driver, enable the "Enable
the bi-direction support" in the "Port" setting of the
properties.
When using a ZPL II compatible printer driver with this product, printing may not be performed.
Check whether printing is possible by using the latest version of the ZPL II compatible printer
driver.
LCD display
Warning type
Description Recovery method
To Next Page
Loading...
Need help?
General
