Operation Manual
Version: 12/01
39
er900L Operation Manual
Art-Nr: 475.043
Ergometer
Type er900L
7.3.6 Other Parameters
Numerous other parameters can be specified by using the monitor program, among
these are:
* analog input/output adjustments, load unit adjustment, etc.
Some of these parameters are code protected and should not be modified by the op-
erator due to safety considerations. Notify your authorized dealer or the ergoline ser-
vice department if you wish to alter any one of these protected parameters.
„Appendix B“ contains setup instructions for the following parameters:
Setting of ECG-Type
Type selection for an attached ECG unit (for data transmission)
TRANSM.SPEED
ECG specific TRANSM.SPEED selection
Toggle between internal and external load control
Determines if load is to be controlled internally (by the ergometer) or externally (by
the ECG unit)
Hardware Tests
Determines if the voltages of the system are correct
Parameters that are
only to be altered by personnel authorized by ergoline :
Blood Pressure Measurement Unit Certification
Test routine that is run by the office of certification
Torque Adjustment
Adjustment of the drive train unit
Analog Output Adjustment
Adjustment of the analog data outputs
Analog Input Adjustment
Adjustment of the analog data inputs
Configuration
To Next Page
Loading...
Need help?
General
