Operation Manual
er900L Operation Manual
54
Version: 12/01
Art-Nr: 475.043
Ergometer
Type er900L
8.2.3 Setup of Program 9, Steady-Pulse (Heart & Circulation Training)
Program 9 is for pulse-steady-state training. The ergometer increments the load from
the outset of training according to your parameters. Upon reaching the maximum heart
rate setting, instead of causing program termination, the unit switches over to pulse-
steady-state control. That means that load changes are calculated to maintain this
heart rate. It is absolutely necessary to provide the ergometer with a continuous heart
rate signal when running the pulse-steady-state program. This can be accomplished
with an ear/finger clip, a pulse monitor or a heart rate feedback from and ECG device.
Once reached, the ergometer will hold the maximum heart rate value stable until an
additional alarm parameter is exceeded or the training session is manually ended by
the operator.
Program Flow:
Patient for pulse-steady-state training
select program 9
Possible change of the maximum heart rate
Start program (quiescent blood pressure measurement)
Print-out of resulting data
Load program start at P
o
Print-out of the loaded data with every blood pressure measurement
Increment the load according to the pre-programmed load increments at the
pre-programmed intervals until the max. heart rate value is reached
Transition to pulse-steady-state control. Load will be
automatically altered in response to the heart rate.
Load program termination (caused by reaching an alarm parameter,
dropping below the minimum RPM rating of 25 RPM or because the „END“
key was pressed - transition to the recuperation phase
Print-out of measurement results for the on-going
blood pressure measurements
Terminate ergometry by again pressing the „END“ key
Output of the summary protocol
Structure of Programs
To Next Page
Loading...
Need help?
General
