120 Summit 200 Series Switch Installation and User Guide
Access Policies
Deleting Access Mask, Access List, and Rate Limit Entries
Entries can be deleted from access masks, access lists, and rate limits. An access mask entry cannot be
deleted until all the access lists and rate limits that reference it are also deleted.
To delete an access mask entry, use the following command:
delete access-mask <name>
To delete an access list entry, use the following command:
delete access-list <name>
To delete a rate limit entry, use the following command:
delete rate-limit <name>
Verifying Access Control List Configurations
To verify access control list settings, you can view the access list configuration.
To view the access list configuration use the following command:
show access-list {name | ports <portlist>}
To view the rate limit configuration use the following command:
show rate-limit {name | ports <portlist>}
To view the access mask configuration use the following command:
show access-mask {name}
Access Control List Commands
Table 32 describes the commands used to configure access control lists.
NOTE
On the Summit 200-48 switch, ACL ingress and egress ports must belong to the same port group. Port
group 1 consists of ports 1 through 24 and port 49; port group 2 consists of ports 25 through 48 and
port 50.
To Next Page
Loading...
Need help?
General
