Fronius Primo GEN24 3.0 Plus User Manual

The text and illustrations are all technically correct at the time of printing. We reserve the
right to make changes. The contents of the operating instructions shall not provide the
basis for any claims whatsoever on the part of the purchaser. If you have any sugges-
tions for improvement, or can point out any mistakes that you have found in the instruc-
tions, we will be most grateful for your comments.
Protective earth-
ing (PE)
Connection of a point in the device, system or installation to earth to protect against elec-
tric shock in the event of a fault. When installing a safety class 1 inverter (see Technical
data), the ground conductor connection is required.
When connecting the ground conductor, ensure that it is secured against accidental dis-
connection. All the points listed in the chapter Connecting the inverter to the public
grid (AC side) on page 58 must be observed. It must be ensured that when using the
strain relief devices, the ground conductor is the last to be disconnected in the event of a
possible failure. When connecting the ground conductor, the minimum cross-section
requirements specified by the respective national standards and guidelines must be
observed.
10

Fronius Primo GEN24 3.0 Plus Specifications

General

Max. input current	12 A
Max. input voltage	1000 V
Protection class	IP66
Max. output current	13 A
THD	< 3%
Max. input current (DC)	12 A
Number of MPP trackers	2
Max. DC short-circuit current	18 A
AC Output Frequency	50/60 Hz
AC nominal output	3000 W
Max. apparent AC power	3000 VA
AC nominal voltage	230 V
Operating Temperature Range	-25 to +60 °C
Cooling	Active cooling
Maximum Input Power	4, 500 W
Warranty	5 years