Intended use The inverter is designed to convert direct current from solar modules into alternating cur-
rent and feed this power into the public grid. A backup power mode is possible provided
that appropriate cabling has been installed.
The following are considered improper use:
- Utilisation for any other purpose, or in any other manner
- Alterations to the inverter are not permitted unless expressly recommended by
Fronius
- Installation of components is not permitted unless expressly recommended or sold
by Fronius.
The manufacturer is not responsible for any damage resulting from improper use.
All warranty claims are considered void in such cases.
Intended use also means:
- Carefully reading and obeying all the instructions, as well as safety and danger
notices in the Operating Instructions
- Installation in accordance with chapter "Installation" from page 43.
When configuring the photovoltaic system, make sure that all components of the photo-
voltaic system are operating exclusively within their permissible operating range.
Observe all measures recommended by the solar module manufacturer to permanently
maintain the solar module properties.
Observe the grid operator's regulations for energy fed into the grid and connection meth-
ods.
The Fronius GEN24 inverter is a grid-connected inverter with a backup power function –
it is not a stand-alone inverter. The following restrictions must therefore be observed in
backup power mode:
- Backup power mode may be in operation for at least 2000 hours
- Backup power mode may be in operation for more than 2000 operating hours if 20%
of the duration of the inverter's grid power feed operation is not exceeded at the rel-
evant time.
* Only possible with Fronius GEN24 Plus inverters.
Thermal concept Ambient air is drawn in by the fan on the
front side and blown out at the device
sides. The even heat dissipation allows
several inverters to be installed next to
each other.
14
To Next Page
Loading...
Need help?
General
