Fronius Primo GEN24 3.0 Plus User Manual

LED status indicator
The inverter indicates a non-critical status.
Flashing yellow
The inverter indicates a critical status and there is no grid
power feed process.
Lights up red
The inverter indicates a back-up power overload.
Flashing red
The network connection is being established via WPS.
2x = WPS search mode.
Flashing green
The network connection is being established via WLAN AP.
1x = WLAN AP search mode (active for 30 minutes).
Flashing blue
The network connection is not configured.
Lights up yellow
The inverter is operating correctly, a network fault is indicated.
Lights up red
The inverter is performing an update.
/ Flashing blue
Installation with
the app
The "Fronius Solar.start" app is needed for this installation method. Depending on the
end device with which the installation will be carried out, download the app for the
respective platform.
1
Start the installation in the app.
2
Select the product to which the connection should be established.
88

Fronius Primo GEN24 3.0 Plus Specifications

General

Max. input current	12 A
Max. input voltage	1000 V
Protection class	IP66
Max. output current	13 A
THD	< 3%
Max. input current (DC)	12 A
Number of MPP trackers	2
Max. DC short-circuit current	18 A
AC Output Frequency	50/60 Hz
AC nominal output	3000 W
Max. apparent AC power	3000 VA
AC nominal voltage	230 V
Operating Temperature Range	-25 to +60 °C
Cooling	Active cooling
Maximum Input Power	4, 500 W
Warranty	5 years