Fax Procedure
143
Fax
4
For information on how to fax mixed sized documents, refer to "Mixed Size Originals (Scanning
Different Size Documents Simultaneously)" (P.177).
1 Remove any paper clips and staples before loading a document.
2 Load the document face up (when the
document is 2-sided, place the front side up)
in the center of the document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, the machine may
be detecting the document on the
document glass. Load the document
again.
3 Adjust the document guides to match the
size of the document loaded.
4 Raise the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
size from 15 x 15 mm (Standard size: A5, A5 ) to 216 x 356 mm (Standard size: A4).
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
Confirmation indicator
To Next Page
Loading...
Need help?
General
