Safety Notes
21
Before Using the Machine
1
Once a month, switch off this product and check if
z
the power cord is plugged firmly into an electrical outlet;
z
the plug is not excessively heated, rusted or bent;
z
the plug and electrical outlet are free of dust; and
z
the power cord is not cracked or worn down.
Once you notice any unusual condition, switch off and unplug this product first
and contact your local Fuji Xerox representative.
Machine Installation
Do not locate this product where people might step on or trip over the power
cord. Friction or excessive pressure may generate heat and eventually cause
electric shock or a fire accident.
Never locate this product in the following places:
z
Near radiators or any other heat sources
z
Near volatile flammable materials such as curtains
z
In the hot, humid, dusty or poorly ventilated environment
z
In the place receiving direct sunlight
z
Near cookers or humidifiers
This product weights 56 Kg. When moving it, always carry it by a team of four
or more persons to avoid mishandling or injury.
When lifting this product, lift it with our persons. The person in front holds the
machine with one hand on each side. Never lift it by gripping any other areas.
It will prevent you from dropping the product and getting back ache or injuries.
Locate this product on a level and sturdy surface that can withstand a weight
of 115 Kg (maximum weight when the One tray module, Two tray module, and
Finisher-AB1 are installed). Otherwise, if tilted, the product may fall over and
cause injuries.
Locate this product in a well-ventilated area. Do not obstruct ventilation
openings of the product.
Keep the minimum clearance as follows for ventilation and an access to the
power plug. Unplug the product if an abnormal condition is noted.
To Next Page
Loading...
Need help?
General
