Fax/Internet Fax Options
183
Fax
4
îš„Delivery Receipts
z
Off
Disables the Delivery Receipts feature.
z
On
Enables the Delivery Receipts feature. You can check whether the Internet Fax you
sent was correctly delivered to the destination folder.
Starting Rate (Selecting a Communication Mode)
You can select a communication mode based on the features of the remote machine.
G3 is the international standard for facsimile transmissions established by the ITU-T.
When you use speed dialing, group dial number or address book to specify a recipient registered in an
address number, the communication mode currently set to the address number is set and cannot be
changed. For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add
Address Book Entry" in the Administrator Guide.
You can change the default mode of [Starting Rate] in the System Administration mode. For
information on how to change the default mode, refer to "5 Tools" > "Fax Service Settings" > "Fax
Defaults" > "Starting Rate" in the Administrator Guide.
1 Select [Starting Rate].
2 Select any option.
îš„G3 Auto
Select this mode if the remote machine is G3 compatible. This mode is normally
selected.
Depending on the reception capabilities of the remote machine, the machine
automatically switches modes in the following order: G3 Unique ECM J G3 Unique J
ITU-T G3 ECM J ITU-T G3.
îš„Forced 4800 bps
Select this mode when transmitting over noisy or poor telephone lines, as can be the
case with overseas calls.
Also select this mode when transmitting over noisy or poor telephone lines
domestically.
About Forced 4800 bps
You can communicate with faxes overseas via telephone company exchanges, etc.
To Next Page
Loading...
Need help?
General
