Job Assembly
141
Copy
3
Job Assembly
This section describes the features you can select on the [Job Assembly] screen. The
following shows the reference section for each feature.
Build Job (Processing Documents Scanned with Different Settings as One Job) .........................................................141
Sample Job (Checking the Finished Output of the Copy)...................................................................................................145
Combine Original Sets (Adding Originals) .............................................................................................................................146
Delete Outside/Delete Inside (Deleting Outside or Inside of the Selected Area).........................................................147
Stored Programming (Calling a Stored Program for Build Job) .......................................................................................148
1 Select [Copy] on the Services Home screen.
2 Select a feature on the [Job Assembly] screen.
Build Job (Processing Documents Scanned with Different Settings as One Job)
This feature allows you to apply different copy settings to each document page or each
document stack, and then output the copies as one job.
1 Select [Build Job].
2 Select [On].
3 Select any option.
Note •Select [ ] to return to the previous screen or
[ ] to move to the next screen.
Off
Build Job is not applied.
On
Build Job is applied. The feature buttons appear. Specify any option if necessary.
To Next Page
Loading...
Need help?
General
