6 Maintenance
140
Emptying the Hole Punch Waste Container (for C3
Finisher or C3 Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the hole punch waste container becomes full, a message appears on the touch screen.
When the message appears, empty the hole punch waste container as instructed.
z
Empty the hole punch waste container when the device is on. If you empty the container while the device is
off, the device does not recognize that the container has been emptied.
z
Empty the hole punch waste container after the message appears. Otherwise, the device cannot recognize
the correct remaining amount of the punch scraps.
z
Make sure to discard all paper chads when emptying the hole punch waste container. Not doing so will cause
the container to fill up before the message telling you to empty the container appears again, and this can
cause device malfunction.
z
When the device is in Power Saver mode, wake the device from the Power Saver mode by pressing the Power
button and select [Machine Status] on the Home screen before you empty the punch waste container.
z
Before emptying the punch waste container, select [Machine Status] on the Home screen and check the
current status for the punch waste container even when the touch screen is lit.
1 Make sure that the device is not operating, and open the finisher front door.
2 Pull out the hole punch waste container [R4].
To Next Page
Loading...
Need help?
General
