Fuji Xerox ApeosPort-VII C7788 User Manual

6 Maintenance
142
Emptying the Hole Punch Waste Container (for
Finisher D6 with Booklet Maker)
When the optional finisher is installed and the hole punch waste container becomes full, a
message appears on the touch screen. Discard the scrap according to the message.
If you take the hole punch waste container out of the device, make sure to empty it
completely. If it is reinstalled with some waste remaining, it may become full before the
message appears again, and this can cause device breakdown.
Important
z
When emptying the hole punch waste container, make sure that the device is switched on. If not switched on,
the device will not recognize that the hole punch waste container has been emptied.
1 Make sure that the device has stopped, and open the finisher front door.
2 Pull out [R4].
3 Discard all the scraps.
4 Push [R4] in to its original position.

Fuji Xerox ApeosPort-VII C7788 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-VII C7788
Category	All in One Printer
Language	English