Connectivity & Network Setup
203
Tools
5
Set DH group. Select from [G1] or [G2].
z
PFS Settings
Select whether or not to enable PFS.
z
Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.
z
Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.
z
Communicate with Non-IPsec Devices
Select whether or not to communicate with non-IPSec devices.
IEEE 802.1X Settings / IEEE 802.1X Settings (Ethernet 1), IEEE 802.1X Settings (Ethernet 2)
Note • When both of the [TCP/IP - Network Settings (Ethernet 1)] setting and the [TCP/IP - Network
Settings (Ethernet 2)] setting are configured, you can configure individual IEEE802.1X settings for
each Ethernet interface.
• The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [IEEE 802.1X Settings] is displayed. When two Ethernet interfaces are
used, [IEEE 802.1X Settings (Ethernet 1)] and [IEEE 802.1X Settings (Ethernet 2)] are displayed.
• When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network
Name], the specified names are displayed instead of "Ethernet1" and "Ethernet2" of [IEEE 802.1X
Settings (Ethernet 1)] and [IEEE 802.1X Settings (Ethernet 2)] respectively.
îš„ IEEE 802.1X Settings
Configure the IEEE 802.1X settings.
z
IEEE 802.1X
Set whether or not to use IEEE 802.1X authentication.
z
Authentication Method
Select from [EAP-MD5], [EAP-MS-CHAPv2], [PEAP/MS-CHAPv2], or [EAP-TLS].
z
Login User Name
Enter the login user name with up to 128 characters.
z
Login Password
Enter the login password with up to 128 characters.
z
Server Certificate Verification
Select whether or not to verify a server certificate when [PEAP/MS-CHAPv2] is selected in
[Authentication Method].
Certificate Revocation Retrieval Settings
Configure the settings for certificate revocation retrieval.
îš„ Level of Certificate Verification
Select a level of certificate verification from [Low], [Medium], or [High].
Selecting [Low] does not verify the validity of certificates.
Selecting [Medium] verifies the validity of certificates. If a certificate cannot be verified
because of a network error or any other problems, the certificate is determined as valid.
To Next Page
Loading...
Need help?
General
