2 Paper and Other Media
56
Paper and Other Media
2
Note • Affix the paper size label to the front of the paper tray.
6 Specify the type of the paper loaded when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.60).
Changing the Paper Size for Tray 6 (HCF (A4 1 Tray)) (Optional)
The following describes the procedure for changing the paper size for Tray 6 (HCF (A4 1
Tray)) (optional).
1 Pull out the tray until it stops.
Important •While the machine is processing a job, do not
pull out the tray that the job uses.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the tray,
and then load the new stack of paper.
2 Remove any paper loaded in the tray.
3 Open the end guide (1) and unscrew the screw
(2). Then remove the guide from the tray.
4 Insert the small protrusions at the bottom of the guide into holes corresponding to the
paper size (1). Insert a screw into a hole corresponding to the paper size on the top of the
guide and tighten up the screw (2).
To Next Page
Loading...
Need help?
General
