EasyManuals Logo
Home>Fuji Xerox>All in One Printer>DocuCentre-V 6080

Fuji Xerox DocuCentre-V 6080 User Manual

Fuji Xerox DocuCentre-V 6080
745 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Replacing Consumables
77
Maintenance
3
6 With holding the tabs, return new cartridge to
the original position, and then gently push the
cartridge in until it clicks into place
7 Repeat steps 3 to 6 to replace the other cartridge.
8 Return the unit to the original position.
9 Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
remain paused.
Emptying the Hole Punch Waste Container (for C3 Finisher, C3 Finisher with
Booklet Maker, D2-Staple-Finisher or D2-Staple-Finisher with Booklet Maker)
When the C3 Finisher (optional), the C3 Finisher with Booklet Maker (optional), the D2-
Staple-Finisher (optional) or the D2-Staple-Finisher with Booklet Maker (optional) is
installed and the hole punch waste container becomes full, a message appears on the touch
screen. When the message appears, empty the hole punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
• Empty the hole punch waste container after the message appears. Otherwise, the machine cannot
recognize the correct remaining amount of the punch scraps.
• When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you empty the punch waste
container.
• Before emptying the punch waste container, press the <Machine Status> button and check the
current status for the punch waste container even when the control panel is lit.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-V 6080 and is the answer not in the manual?

Fuji Xerox DocuCentre-V 6080 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-V 6080
CategoryAll in One Printer
LanguageEnglish

Related product manuals