2 Paper and Other Media
54
Paper and Other Media
2
Inserter allows you to set paper (blank, copied paper, etc.), which will only be used as
separators and covers, so that the machine does not output on the paper loaded in this tray.
Note • Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper jams or
any other troubles. First, remove the remaining paper from the tray, and then load the new stack of
paper.
1 Hold the center of the paper guides and slide
them to the desired paper size.
2 Load the paper, neatly aligning all edges.
Important •Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
Loading Tab Paper in Tray T1 (Inserter) (Optional)
The following describes the procedure for loading tab paper in Tray T1 (Inserter) (optional).
1 Hold the center of the paper guides and slide
them to the desired paper size.
2
If the paper is already printed on, load the
paper with the printed side facing up and with
the tab side to be fed first.
Important •Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
To Next Page
Loading...
Need help?
General
