16 Appendix
626
Appendix
16
Fold Position Adjustment
This section describes how to adjust the fold position.
You can adjust the fold position for each paper type, and save 10 types of adjusted values.
You can assign a set type to each tray.
You can adjust the fold position for single fold, booklet, C fold, Z fold, Z fold half sheet.
Fold Position Adjustment
1
Load the paper to adjust the fold position in the tray.
2 Press the <Log In/Out> button, and then enter the System Administration mode.
For more information on how to enter the System Administration mode, refer to "System Settings Procedure" (P.112).
3 Select [Tools] on the Services Home screen.
4 Select [System Settings] > [Common Service Settings] > [Maintenance].
5 Select [Finisher Adjustment].
Note • Select [ ] to return to the previous screen or
[ ] to move to the next screen.
6 Select [Adjust Fold Position].
7 Select [Fold Position Type Setup], and then
select [Change Settings].
8 Select a type, and select [Change Settings].
To Next Page
Loading...
Need help?
General
