To Next Page

To Previous Page

4 Fax

220

Fax

1 Check [Preview], set each item, and press the

<Start> button.

2 Preview the read images while reading the next job.

For how to preview the read image, refer to "Previewing the Read Images during a Fax Job" (P.198).

Resolution (Specifying the Scanning Resolution)

You can set the resolution for the documents to be scanned.

Note • The machine scans a document at the specified resolution, but if the recipient's machine does not

support the resolution, the machine automatically changes the resolution to one supported by the

recipient's machine and there is a corresponding loss in quality.

• The higher the resolution, the lower the transmission speed. Usually, we recommend that you select

[Superfine (400 dpi)] or lower.

• Only [Fine (200 dpi)] is available for the Server Fax service.

You can specify the resolution for each address number. For information on how to register address numbers, refer to "5

Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.

1 Select [Resolution].

 Standard (200 x 100 dpi)

Select this option when transmitting standard documents.

(200 x 100 pels/25.4 mm)

 Fine (200 dpi)

Select this option when transmitting documents with small text or detailed images.

(200 x 200 pels/25.4 mm)

 Superfine (400 dpi)

Select this option when transmitting documents with fine images.

(400 x 400 pels/25.4 mm)

 Superfine (600 dpi)

Select this option when transmitting documents with extremely fine images.

(600 x 600 pels/25.4 mm)

Fuji Xerox DocuCentre-V C7785 User Manual

Other manuals for Fuji Xerox DocuCentre-V C7785