Using the Operator Panel Menus 153
Billing Meters
Use Billing Meters to check the total number of printed pages.
NOTE:
• A password is required to enter the operator panel menus when Panel Lock Set is set to Enable. In this
case, enter the password you specified, and press the
button.
Values:
Admin Menu
Use Admin Menu to configure a variety of printer features.
NOTE:
• A password is required to enter the operator panel menus when Panel Lock Set is set to Enable. In this
case, enter the password you specified, and press the button.
Network Setup
Use the Network Setup menu to change the printer settings affecting jobs sent to the printer
through the wired or wireless network.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
•Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the printer is turned off and then on.
Values:
NOTE:
• For the DocuPrint CP215 w, this item is not displayed when the Ethernet cable is disconnected and
Wireless LAN is set to Enable.
Meter 1 Displays the total number of color prints.
Meter 2 Displays the total number of monochrome prints.
Meter 3 Always shows 0 on your printer.
Meter 4 Displays the total number of color and monochrome prints (Meter 1 +
Meter 2).
Auto* Detects the Ethernet settings automatically.
10Base Half Uses 10base-T half-duplex.
10Base Full Uses 10base-T full-duplex.
100Base Half Uses 100base-TX half-duplex.
100Base Full Uses 100base-TX full-duplex.
To Next Page
Loading...
Need help?
General
