192 Troubleshooting
Auger Mark
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorized dealer.
Problem Action
The printed result has auger
mark.
The toner cartridges may be low or need to be replaced. Confirm the
amount of toner in each toner cartridge.
1 Check the toner level in the Status tab in the Status Monitor
window.
2 Replace the toner cartridges as necessary.
Start Developer Stir Mode.
1 Launch the Printer Setting Utility, and click Developer Stir Mode
on the Diagnosis tab.
2 Click the Start button.
To Next Page
Loading...
Need help?
General
