212 Troubleshooting
Non Genuine Toner Mode
When toner within a toner cartridge is empty, the Replace XXXX Cartridge or Empty XXXX
Cartridge (XXXX: Yellow, Magenta, Cyan, or Black) message appears.
When you want to use the printer in the Non Genuine Toner mode, enable the Non Genuine Toner
mode and replace the toner cartridge.
IMPORTANT:
• If you use the printer in the Non Genuine Toner mode, the performance of the printer may not be at its
optimum. Any problems that may arise from the use of the Non Genuine Toner mode are not covered by our
quality guarantee. The continuous use of the Non Genuine Toner mode can also cause the printer to break
down, and any repair charges for such break down will be incurred by users.
NOTE:
• To disable the Non Genuine Toner mode, select Off for Non-GenuineToner on the operator panel or
deselect the check box next to On on the Non Genuine Toner page on the Printer Setting Utility.
Using the Operator Panel
NOTE:
• Before starting the operation described below, confirm that Ready is displayed on the LCD panel.
1 Press the (Menu) button.
2 Select Admin Menu and then press the button.
3 Select Maintenance Mode and then press the button.
4 Select Non-GenuineToner and then press the button.
5 Select On and then press the button.
6 Press the (Menu) button to exit the Menu mode.
The printer switches to the Non-GenuineToner mode.
Using the Printer Setting Utility (Windows Only)
The following procedure uses Windows 7 as an example.
1 Click Start → All Programs → Fuji Xerox → Fuji Xerox Printer Software for Asia-Pacific →
your printer
→ Printer Setting Utility.
NOTE:
• The Select Printer window appears in this step when multiple print drivers are installed on your
computer. In this case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility opens.
2 Click the Printer Maintenance tab.
3 Select Non Genuine Toner from the list at the left side of the page.
The Non Genuine Toner page is displayed.
4 Select the check box next to On, and then click the Apply New Settings button.
To Next Page
Loading...
Need help?
General
