Using the Operator Panel Menus 163
•Adjust ColorRegi
Purpose:
To specify whether to manually adjust color registration.
Color registration adjustments need to be made during the initial setup of the printer or when the
printer is moved to a different location.
NOTE:
• The Adjust ColorRegi feature can be configured when Auto Regi Adj is set to Off.
Values:
• Clear Developer
Purpose:
To rotate the developer motor and stir the toner in the toner cartridge.
• Toner Refresh
Purpose:
To use up a toner cartridge when you need to replace it before the end of its life, or to stir the toner in
a new toner cartridge.
Values:
Auto Adjust Automatically corrects color registration.
Color Regi
Chart
Prints a color registration chart. The color registration chart prints a lattice pattern of
yellow, magenta, and cyan lines. On the chart, find the values on the right side that
are next to the line that is perfectly straight for each of the three colors. If the value
for this line is 0, color registration is not needed. If the value for this line is any value
other than 0, specify the adjustment values under Enter Number.
Enter Number Enter (Y, M, C) 0, 0, 0* Specifies lateral (perpendicular to paper feed
direction) color adjustment values individually
for Y (Yellow), M (Magenta) and C (Cyan).
-5 – +5
Enter (LY, LM, LC) 0, 0, 0* Specifies process (paper feed direction) color
adjustment values individually for LY (Left
Yel low) , LM (Left Magenta) and LC (Left
Cyan).
-5 – +5
Enter (RY, RM, RC) 0, 0, 0* Specifies process (paper feed direction) color
adjustment values individually for RY (Right
Yel low) , RM (Right Magenta) and RC (Right
Cyan).
-5 – +5
Yellow Cleans the toner in the yellow toner cartridge.
Magenta Cleans the toner in the magenta toner cartridge.
Cyan Cleans the toner in the cyan toner cartridge.
Black Cleans the toner in the black toner cartridge.
To Next Page
Loading...
Need help?
General
