Troubleshooting 185
The Output Is Too Light
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorized dealer.
Problem Action
The output is too light. The toner cartridges may be low or need to be replaced. Confirm the
amount of toner in each toner cartridge.
1 Check the toner level in the Status tab in the Status Monitor
window.
2 Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
•"Usable Print Media" on page 108
Try changing the paper type setting in the print driver. The following
procedure uses the Microsoft
®
Windows
®
print driver as an example.
1 On the Paper/Output tab in Printing Preferences of the print
driver, select Advanced Paper Selection from the Paper drop-
down menu.
2 Change the Bypass Paper Type setting.
3 Load dry (not damp) and correct print media, and then click Print
Test Page in the Properties window of the print driver.
Disable the toner saving feature in the print driver.
See also:
•"Conserving Supplies" on page 231
To Next Page
Loading...
Need help?
General
