Printing Basics 137
Loading Envelopes in the Priority Sheet Inserter (PSI)
Follow the guidelines below to load envelopes in the PSI.
NOTE:
• Be sure to insert envelopes all the way in. Otherwise, print media that is loaded in the paper tray will be fed.
• When you print on envelopes, be sure to specify the envelope on the print driver. If not specified, the print
image will be rotated 180 degrees.
• If you do not load envelopes in the PSI right after they have been removed from the packaging, they may
bulge. To avoid jams, flatten them as shown below before loading them in the PSI.
• If envelopes are still not fed correctly, add some bending to the flap of the envelopes as shown in the following
illustration. The amount of the bending shall be 5 mm (0.20 inches) or less.
IMPORTANT:
• Never use envelopes with a window or coated linings as it causes paper jams that may result in damage to the
printer.
To Next Page
Loading...
Need help?
General
