Fuji Xerox DocuPrint P255 d User Manual

168 Using the Operator Panel Menus
• Initialize NVM
Purpose:
To initialize wired network data stored in Non-Volatile Memory (NVM). Enabling this feature and
rebooting the printer will reset all the wired network settings to their factory default values.
Values:
• PS Data Format
Purpose:
To set the PS data communications protocol. To make any changes effective, turn off the printer and
then turn it back on.
Values:
System Settings
Use the System Settings menu to configure a variety of printer features.
• Power Saving Timer
Purpose:
To specify a time period before the printer enter each power saver mode.
Values:
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room
lights and you notice them flickering. Otherwise, select a high value to keep your printer available for
frequent use with the minimum warm-up time.
The printer automatically exits a power saver mode when it receives a print job from a computer.
Alternatively, you can manually bring it back to the ready-to-print state by pressing the (Energy
Saver) button. Whether the printer is in Low Power or Sleep mode, it will take about 25 seconds for
the printer to resume the ready-to-print state.
Yes Initializes the wired network data stored in NVM.
No* Does not initialize the wired network data stored in NVM.
* Factory default menu setting
Auto* Sets the PS data communications protocol automatically.
Standard Sets the PS data communications protocol to Standard.
BCP Sets the PS data communications protocol to BCP.
TBCP Sets the PS data communications protocol to TBCP.
* Factory default menu setting
Low Power
Timer
1min* By default, the printer enters Low Power mode in one minute
of inactivity after completion of the last job. You can change
the Low Power Timer setting within a range from 1 to 30
minutes.
1min - 30min
Sleep Timer 6min* By default, the printer enters Sleep mode in six minutes of
inactivity starting from the moment it entered Low Power
mode. You can change the Sleep Timer setting within a
range from 6 to 11 minutes.
6min - 11min
* Factory default menu setting

Fuji Xerox DocuPrint P255 d Specifications

General

Brand	Fuji Xerox
Model	DocuPrint P255 d
Category	Printer
Language	English