Printer Connection and Software Installation 61
Network Connection Setup
NOTE:
• To use your printer in a Linux environment, you need to install print drivers for the Linux operating systems.
For details on how to install and use the drivers, see also "Installing Print Drivers on Computers Running Linux
(CUPS)" on page 103.
• When using a CD drive in a Linux environment, you need to mount the drive to your system environment. The
command strings are mount/media/CD-ROM.
The following procedure uses Windows 7 as an example.
1 Click Installing Drivers and Software.
2 Select Network Installation, and then click Next.
3 If you agree to the terms of the License Agreement, click I accept the terms of the license
agreement to continue the installation process, and then click Next.
4 Select the printer you want to install from the printer list, and then click Next. If the target printer
is not displayed on the list, click Refresh to refresh the list or click Add Printer to add a printer to
the list manually. You may specify the IP address and port name at this point.
If you have installed this printer on the server computer, select I am setting up this printer on a
server check box.
NOTE:
• If the installer displays 0.0.0.0 when you intend to use the AutoIP feature, you must enter a
valid IP address to continue.
5 Specify the printer settings, and then click Next.
a Enter the printer name.
b If you want other users on the network to access this printer, select Share this printer with
other computers on the network, and then enter a share name that users can identify.
c If you want to set a printer as the default for printing, select the Set this printer as default
for printing check box.
6 Select the software and documentation you want to install, and then click Install. You can specify
folders in which to install the software and documentation. To change the folders, click Browse.
7 Click Finish to exit the wizard.
To Next Page
Loading...
Need help?
General
