137
6.4 Settings for IC Card Reader Authentication
2. Touch the unregistered Smart Card over the IC Card reader of the machine to authenticate as the
[Guest User].
3. Tap on [Smart Card Registration].
4. Select [Local Machine] for [Domain]. And enter your ID and password noticed by the system
administrator. And then tap on [Register].
Re-registration of Card
If you need to re-register (overwrite) a different Smart Card which is not the same Smart Card as you
have ever used.
1. Operate the same procedures as described in "New Registration" (P.136).
2. Tap on [Register] on the screen displayed.
3. Tap on [OK].
6.4 Settings for IC Card Reader
Authentication
With this, you can perform authentication using information registered to an IC Card, collate
information registered to an IC Card with user information registered to the machine, and perform
accounting tasks for usage restrictions, jobs and other machine data.
Step 1: Set a Joint Password For Use With the IC Card
In remote accounts, set whether to ask for a password when logging in to the machine using an IC
Card.
1. Tap on > [Device] > [Authentication/Accounting] > [Authentication/Security Settings] >
[Authentication] > [User Details Setup].
2. Tap on [IC Card Link Mode] > [Type Password].
Step 2: Logout Method When Using an IC Card
Set how to log out authentication when using an IC Card.
1. Tap on > [Device] > [Authentication/Accounting] > [Authentication/Security Settings] >
[Authentication] > [User Details Setup] > [Contactless IC Card Logout Timing].
To Next Page
Loading...
Need help?
General
