169
10.2 Emulation
Changing the command
There are commands to change the corresponding print language.
Automatic change
The machine analyzes the data received by the host interface and automatically identifies the print
language.
Protocol dependence
You can fix the print language for each protocol (USB, IPP, LPD, Port9100, WSD).
Log in to Administrator Mode in Internet Services, and set Print Mode for each protocol in [USB] or
[Protocols] of the [Connectivity] tab.
Available font
User-defined characters (external fonts) can be used with ESC/P.
User-defined characters are registered as bitmap fonts and saved even after the power is turned off.
Sharing between print languages is not possible.
Print Function
N Pages
2 pages are available.
Form
You can register standard forms and print the registered forms by synthesizing them into print data.
If you try to register more forms than the maximum number of forms to be registered or if the form
memory reaches full capacity, new forms cannot be registered.
Barcode
Barcode standards available for ESC/P are JAN code, CODE39, CODABAR, Industrial 2 of 5, Matrix 2
of 5, and Interleaved 2 of 5.
Barcode standards available for PCL are CODE39, CODE128, CODABAR, UPC, EAN, Postal barcode
of Japan and QR code.
Output of Related List
For details, refer to "[Print Reports]" (P.38).
Font
Available font can be confirmed by executing [Print] for [Font List] or [PCL Font List] in > [Device
Status] > [Print Reports] > [Printer Reports].
Emulation mode N Pages Form Barcode
ESC/P Yes Up to 64 Yes
PCL - - Yes
HP-GL, HP-GL/2 - - -
To Next Page
Loading...
Need help?
General
