Fujitsu ASU9CQ User Manual

920-007-14
Electrical Shock Hazard
Do not use plug adapters.
Do not use an extension cord.
Do
not remove ground prong.
Replace damaged cords with new cord from
manufacturer.
Failure
to follow these instructions can result in
death, fire,
or electrical shock.
Never use an extension cord
Your Friedrich room air conditioner is equipped with a three-prong
(grounded) plug for your protection against shock hazards and should
be plugged directly into a properly grounded three-prong receptacle.
If you have a two-prong receptacle you will need to have the circuit
replaced by a certified electrician with a grounded circuit that meets
all national and local codes and ordinances. Under no circumstances
should you remove the ground prong from the plug. You must use the
three-prong plug furnished with the air conditioner.
NEVER CUT OR REMOVE THE GROUNDING PRONG FROM THE
PLUG.
Power cord information
All Friedrich room air conditioners are shipped from the factory with
a Leakage Current Detection Interrupter (LCD I) equipped power
cord. The LCDI device meets the UL and NEC requirements for cord
connected air conditioners effective August 2004.
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (See Figure 6).
3. Press TEST (listen for click; Reset button trips and pops
out).
4. Press and release RESET (listen for click; Reset button
latches and remains in). The power supply cord is ready for
operation.
NOTE: LCDI device is not intended to be used as a switch.
Once plugged in the unit will operate normally without the need to
reset the LCDI device.
If the device fails to trip when tested or if the power supply cord
is damaged it must be replaced with a new supply cord from the
manufacturer. We recommend you contact our Technical Assistance
Line at (800) 541-6645 ext. 662. To expedite service, please have your
model and serial number available.
NOTE: Your LCDI device will resemble one of these illustrations.
/
Figure 6
RESET
00
WARNING
TEST BEFORE EACH USE
1, PRESS RESET BUTTON
2. PLUG LCCI INTO f'ClVYER
RECEPTACt.E
3. PRESS TEST BUTTON,
REser BUTTON SHOULD
• POPUP
4. PRESS TEST BlJTTOO,
FOR USE
00 NOT USE IF ABOVE TEST
FAILS
VI'l-IEN
GREEN LIGHT IS ON
IT IS WORKING PRClPERLY
\
•
~
•
/\I~
/'
0
1
/
I I
8

Fujitsu ASU9CQ Specifications

General

Brand	Fujitsu
Model	ASU9CQ
Category	Air Conditioner
Language	English