AIR
CLEANING
OPERATION
If you wish to eliminate dirt,dust,cigarette smoke, pollen,
or
just
simply
purify the
air
of
the room,
use
the
Air
Cleaning Mode.
1
Press
the START/STOP button (Fig. 6 @).
The operation indicator lamp
will
light up (red,
as
shown in the figurel.
(If
the unit is already in operation, please proceed
to
step
2.)
Press
the
AIR CLEAN button (Fig. 6 @).
2
The
AIR
CLEAN
indicator lamp (Fig. 3
(VI
will
light up (green,
as
shown in
iliefi~re~
.
•
Air
conditioning and
Air
Cleaning
will
function simultaneously.
CIf you wish
to
stop Air Clean
J
Press
the
AIR
CLEAN
button (Fig. 6 @) once again.
The
AIR
CLEAN
indicator
lamp
(green)
will
switch
off
(as shown
in
the figure).
• This will
only
stop the
Air
Cleaning,
the
air
conditioner will continue operating.
(
To
also stop
the
air conditioner J
Press
the
START/STOP
button
(Fig. 6 @).
The
operation indicator lamp (Fig. 3 ®) will go out (red,
as
shown in the figurel.
• The next
time
the
START / STOP
button
(Fig. 6 @) is pressed air conditioning
and air cleaning
will
both
resume operating.
• During operation, the unit produces a small amount
of
ozone that
can
be
smelled.
• When this
unit
is used in
combination
with
the ultrasonic
humidifier,
white
particles may become attached to the plasma filter unit.
Ifthis
happens, clean the
plasma filter unit
as
soon
as
possible. (Refer to page
14.)
• The air cleaning operation cannot remove gases such
as
carbon monoxide and
alcohol
from
the air. During operation, ventilate the room often
to
prevent as-
phyxiation
or
suffocation.
•
If
the
intake
filter
is removed
during
operation, a safety device
will
stop
the
operation
of
the plasma filter unit.
If
this happens, the air clean indicator lamp
(green) on the indoor unit will flash after some
time
has passed. Use the STARTI
STOP
button on the remote
controller
to
stop the operation, install the intake
filter, and then use the START/STOP button
to
restart the operation.
• Use the
FAN
CONTROL button
to
change
the
fan speed. (Refer to page
6.)
The
plasma filter unit operates most effectively at the highest fan speed.
• The air clean indicator lamp
will
flash
to
inform you that the periodic cleaning
of
the plasma filter unit
is
required. (Refer
to
page
14.)
En-7
To Next Page
Loading...
Need help?
General
