PREPARATION
&CAUTIONI
~~_u_r_n_o_n
__
t_h_e_p_o_vv_e_r
______________________________
~J
In
the case
of
a direct line connection, turn
on
the circuit
breaker.
Load Batteries (R03
I LR03 x 2)
1
Press
and slide
the
battery compartment lid on
the
re-
verse side
to
open it.
Slide in the direction
of
the
arrow
while pressing the [!I mark.
$
Insert batteries.
2
Be
sure
to
align the battery polarities (Ef)/8l correctly.
3
Close the
battery
compartment lid.
[
Set
the Current
time
•
Take
care
to
prevent infants from
accidentally swallowing batteries.
• When not using the remote control
unit
for
an
extended period, remove the
batteries
to
avoid possible leakage and
damage
to
the unit.
• If leaking battery fluid comes in contact
with
your skin, eyes,
or
mouth,
immedi-
ately wash with copious amounts
of
water, and consult you r physician.
• Dead batteries should
be
removed
immediately and disposed
of
properly,
either in a battery collection receptacle
or
to
the appropriate authority.
.Do not attempt
to
recharge dry batteries.
Never
mix
new and used batteries,
or
batteries
of
different types.
Batteries
should
last
about
one
year
under normal
use.
If the remote control
unit's operating range becomes appre-
ciably reduced, replace the batteries and
press the
ACL
button
with
the
tip
of
a
ballpoint pen
or
other small object.
1
Press the
TIME
ADJUST
button (Fig.
6@).
Use the
tip
of
a ball-point pen
or
other small object
to
press the button.
2
Use the
EB
I e SET TEMP. I SET TIME buttons (Fig. 6
@)
to
adjust
the
clock
to
the
current time.
ED
button: Press
to
advance
the
time.
e button: Press
to
reverse the time.
(Each
time
the
buttons are pressed, the time will
be
advanced/reversed in
one-minute increments;
hold
the
buttons depressed to change the
time
quickly in ten-minute increments.)
3
Press
the
TIME
ADJUST
button again.
This completes the
time
setting and starts the clock.
To
Use
the
Remote Control
Unit
• The Remote Control
Unit
must
be
pOinted at signal receiver (Fig. 1 @)
to
operate
correctly.
• Operating Range:
About
7 meters.
• When a signal is properly received
by
the air conditioner, a beeping
sound
will
be
heard.
•
If
no beep is heard, press the Remote Control
Unit
button again.
Remote Control
Unit
Holder
J
Insert "
G)
Mount
the
Holder. ® Set
the
Remote Control
Unit.
G)
To
remove
the
Remote
Control
Unit
[when use
at
hand).
En-4
To Next Page
Loading...
Need help?
General
