Fujitsu PRIMERGY TX100 S3 Core Edition Upgrade And Maintenance Manual

178 Upgrade and Maintenance Manual TX100 S3 Core Edition
Front panel and external connectors
13.1.2 Preliminary steps
Before replacing the front panel cable, perform the following steps:
Ê Shut down the server as described in section "Shutting down the server" on
page 40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting the power cord" on page 41.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 43.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 60.
Ê Remove all accessible drives as described in section "Removing accessible
drives" on page 163.
Ê Remove the front cover as described in section "Removing the front cover"
on page 49.
13.1.3 Removing the On/Off button
Figure 110: Removing the On/Off button
Ê Press the two retaining clips together and push the On/Off button into the
chassis.
I Note the orientation of the On/Off button. If it is installed differently, it
will not work properly.

Fujitsu PRIMERGY TX100 S3 Core Edition Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3 Core Edition
Category	Server
Language	English